how do you wire up a 1965 mustang brake light switch?

The 1965 Mustang was the first of the classic Mustangs, and it was a car that was loved and cherished by many. But if you're looking to restore one of these beautiful cars, you'll need to know how to wire up the brake light switch. This is a simple process, but it's important to follow the correct steps to ensure everything works correctly.

The first step is to locate the brake light switch. This can be found on the driver's side of the dashboard, just above the steering wheel. Once you have located the switch, you will need to remove the old wiring for the brake light and install new wiring. You will need to connect the red wire to the positive terminal of the battery, and then connect the black wire to the negative terminal.

Next, you will need to connect the new wiring from the brake light switch to the existing wiring harness. Make sure you connect the red wire to the positive terminal, and the black wire to the negative terminal. Once these connections have been made, you will need to connect the ground wire to the chassis, near the brake light switch.

Finally, you will need to connect the new wiring to the brake light switch. This is a relatively simple process, as you will simply need to connect the two terminals on the switch itself. Once all of the connections are made, you will need to test the brake light switch to make sure it is working properly. If everything is working correctly, you should see the brake light illuminate when you press the brake pedal.

By following these steps, you can easily wire up the brake light switch on your 1965 Mustang. Once you have completed the process, you can rest assured that your classic car is now ready to hit the road again.

How To Install A Scott Drake Under Dash Wiring Harness On An Early Mustang Holley Motor Life